Easy to make a laser pointer

There are many Laser pointer
on the market, so you must have a clear observation and sufficient
basic knowledge before making a decision. Laser enthusiasts choose laser
pointers from reliable suppliers. Knowing what you need is always a
good choice.Both the cd on the laptop or the cd on the laptop can be
filled until the laser head becomes obsolete or obsolete. You need an
old DVD disc (with a brand new electronic counter, MCG will not stop
you), preferably 16X, of course 8X is also good, but the power is much
lower, generally only 140mW, much less power.

https://www.htpow.com/300mw-green-high-power-laser-pointer-waterproof-adjustable-holster-p-1038.html

Of course, the first step is to dismantle the beams. Turn the light
actuator over and use a Phillips screwdriver to turn the screwdriver
into four corners. After opening the lid, you can see two integrated
circuits: one large and one small. Then pry open the locks on both sides
of the big board, remove all the front and rear cables, and then you
can pick it up. The so-called bald head is located at the bottom of the
board, between two metal rollers. There are fixing screws at both ends
of the sliding rod. You just need to unscrew the bottom of the reptile
on the left. Remove the smooth headband and remove it from the optical
drive. Turn off the flashlight, remove the light from the tube, and
restart the head of the laser module that was just taken out. If the
lens is a plastic bulb, it must be removed to avoid being melted by the
high-energy laser. Finally, put the lamp back in its original position
and the battery back to its original position.