Pepé Le Pew for 3d print

ATTENTION: There are two versions of the same file.One with her tail close to her body and one with her apart.Print the hollow tail so that the statue does not fall back. This is a different piece and needs more care in printing so that it doesn't fall off. Glue the brackets together. Any engineering problem in the part, please advise for corrections to be made.

================================================IMPORTANT=======================================

The models were made based on centimeters.

Some slicers like Chitubox and Lychee among others are configured to work in millimeters.

When importing the model and it does not appear, increase the scale to 1000000 and the model should appear in the correct scale.

Any problems send a message before leaving a negative note. Thanks.

=================================================================================================

A tribute to the characters from the 1930–1969 animation

• In four parts to avoid seams.
• Total points: 1.118.000
• Hight: 10 cm

Includes:

• OBJ files
• FBX files
• STL files