8 minute face shield 1mm extruder tip settings Free 3D print model

Down from two hours to print to Now only 7 minutes to print, and one minute to assemble. 8 minutes Done.

This is a single face sheild,,, minus A4 Sheet of clear plastic and some elastic or string. my A4 plastic sheet is a clear file cover i found and poked holes in with solder iron, or use a hole punch sisors or pen.

Print notes. New settings.

print settings. FILE V33"" Done on my makerbot replicator. notes to self v29 gcode settings.

1mm extruder tip. yip i drilled it out. ########******************infill. 0%layer hight. .6number of shells 1feedrate mm/s 60Travel feedrate 85print temp 235

HBP 32

PLA

Magnetic flexable build plate, builders tape. sometimes scuff tape a little with sand paper.

This file worked well and printed at these settings.
Print clean up, almost none, i'd call it very clean.

use at own risk,

often used over air filtering breathing mask. check with your health profesinals for advise, i am not quilified to offer medical advice or anything.I'd wear a mask under visor, and keep distance add meters,clean hands and everything.

end of print notes. Good luck be well, ok good work.

Thanks also to friends.Aaron Snow.CGTrader.Filabot.Jo.Thingiverse.Tribotix.Zabaware.

Bye for now and be well from Will and Mr Data :) :]

i downloaded similar design from https://www.thingiverse.com/thing:4241448 so attrabution to them, i've re drawn from scratch.Filabot has a blog on there website which has another visor and a ventertator splitter so check that out.A google search has a lot of 3d printed covid related stuff of course.Hope faster print helps.Bye for now and be well.