Lamp Number 3 Free 3D print model

The results of playing with Autodesk's updated Meshmixer

It's hollow so it could be made into a lamp

Gallery image was printed with these Makerware settings:
*Note: Model was placed below the printing plane to obtain a flat surface

• PLA 180˚C
• Scale:
  • Up 1000% (to make it into its exported centimeter units)
  • And then down 50%
• High setting
  • 15% infill
  • 2 shells
  • 0.1mm
  • 90mm/sec while extruding
  • 150mm/sec while traveling

*No Rafts or supports were needed