Judge Wig and Gavel for Beast Wars Transmetal 2 Megatron Free 3D print model

Here's something of a callback to a fun little scene featured towards the tail end of Beast Wars where TM2 Megatron literally judged if Quickstrike was a traitor to the cause :P

A stickler for accurate protocol no doubt, Megatron donned a Judge's wig and brandished a gavel to add gravitas to the proceedings!

And in all fairness, who else but Waspinator was appointed to defend Quickstrike and basically was down with Megatron slagging Two Head :P

(Floating Platform seen above is available here -https://www.patreon.com/posts/41819875. Tensegrity display base addon: https://www.patreon.com/posts/49214130)

===

This is a rather easy to put together two piece set, but due to being an older figure, the sizing on Megatron's hand is not exactly 5mm, so a little re-sizing for the gavel may be required. For fitting of the wig onto other versions of TM2 Megatron, some re-scaling of the digital file before printing may be needed too.

===

Well then, if you ever wanted to inject some legal drama into your Beast Wars display setup, you're all good to go now! The court adjorns... :P

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog