Legion Go Dock for Bottom USB C - IVANKY Free 3D print model

Legion Go Dock for Bottom USB C - IVANKY Dock

2 Versions:

• Straight
• Leaning

If you have a USB C dock that cannot utilise the bottom USB C like theIVANKY (https://www.amazon.com.au/dp/B0CGVB39C6?ref=ppx_yo2ov_dt_b_fed_asin_title) brand dock that I have, this is the best way to use that bottom port without putting strain to both ports and cable. The top USB C can be used either byan eGPU connection or another pheripheral. The ivanky plug is a bit thikcer than other brand i own. So check the Seal dimension, it should be a silhouette of your 90degree plug. There is a notch on the frant lip to accomodate mic and bottom part of the screen.

Let me know if you have a request for your sopecific dock, i can make one for ya.

The whole length of the dock can be printed on most 3D printers diagonally (45deg) using either PLA or PETG. Use 8mm-10mm Brim to avoid lifting on far edges if your bed isn't completely flat. Use supports but make sure it's not too dense for easy removal.

Buy me a Coffee! https://paypal.me/arviverona?country.x=NZ&locale.x=en_US