Got ties to replace on your line? This Tie Shear can cut it and how.

This is based loosely on a Nordco prototype.

Tie shear comes in several pieces and requires you to file and sand some parts like the engine top and bottom to fit. Glue Wheelset_Rear in place first before Engine_Bottom. You will see tabs on the frame where components fit in between. Test fit to make sure and use the 3D photos here as a guide.

While there is a slot under the cab floor on the frame for the Steps pieces to slide into, I found I had to trim off the ends and sand a bit to make them fit.

There are various 0.5mm holes on the model for you to use a fine wire to make hoses if you like.

Storage boxes can be placed as you like.

Please do not distribute the STLs or make print copies for others. Design is for your own personal use only.