KV-1 tracks 3d print 3D print model

Tracks print up nicely. I assembled mine using wire instead of the track pins. Tracks do not fit Trumpeter Models 1/35 scale drive sprockets, the pitch is a bit off so the tracks do not fit down into the sprocket teeth around the sprocket, however, this very will could be the fault of Trumpeter and their version of the sprocket. It will not be too difficult to modify the Trumpeter drive sprocket to fix the issue. Highly recommended.

The Tracks are great! Printed with no problem and with really no clean-up. I have purchased other track kits and they have required lots of work removing flashing and reaming out the pin holes. The pitch for the drive socket is tight but was able to make them work on the Tamiya kit. The track pins are too weak at 1/35 so I used 0.020 wire.

DON‘T apply to Trumpeter，tooth pitch too narrow，The drive wheel cannot be snapped in，It should work in Tamiya KITS