BBS E52 plus Tire with an Offset variation 3D print model

Set of the BBS E52 wheels model, together with the Michelin Pilot Sport tire, in 1:24 scale.The modeling of the piece is proprietary, it is not a 3D model purchased on the internet, you will not find another like this. The object's detail quality is incredible and will make your miniature even more beautiful.The package contain tow sets of tire, rim and the center of the wheel (rear and front), to be easier to paint.The images in this listing are renderings of the 3D model, as well as images of the model itself in modeling software. They look great on vehicles from europe, VW, Porsche, Audi, etc.The photos where the wheels are printed and painted were sent by our friend and modeler Aldecir Giusti who will use them on a VW SP2 (Brazilian sports car)

Measurements - 1/24Wheel diameter: 20.00 mmPin hole diameter (D): 2.00 mmPin diameter (C): 5.00 mmTotal diameter - Wheel and Tire (A): 24.00 mmWheel width: 10.00 mmTotal width (B): 10.00 mm

Measurements - 1/24 - RearWheel diameter: 20.00 mmPin hole diameter (D): 2.00 mmPin diameter (C): 5.00 mmTotal diameter - Wheel and Tire (A): 26.00 mmWheel width: 13.00 mmTotal width (B): 13.00 mm

For other scales you can use the scale table below:

1/64 - 37.5% (Not tested)1/32 - 75% (Not tested)1/25 - 96%1/24 - 100%1/18 - 133.3333%1/12 - 200%1/10 - 240%1/8 - 300%

3D printing settings

You can print with a layer height of 50μm, if you want a higher level, with 40μm you will have a better result. Layers smaller than this will make no difference.Other printing details depend on the resin you use and the printer, but do not require special care.