Project IronHorse Conversion Kit For Lancing Knights 3D print model

Now with supported files for resin printers!

Added four larger shields for Dominator and Cervantes mechs, as well as a pair of forward-facing shield adapters.

If you are keen to make your Knight a close-combat juggernaut, trampling everything on the battlefield and skewering other knights and monsters like wieners over a fire, I have a large file for you.

Actually, I have a few dozen large files for you.

Scroll through the pictures. I hope I captured the potential this kit has.

For the lances, you will notice two different designators: Slimline and Dominator. Dominator is intended for converting larger, beefier creations to have the Power Lance and shields. Slimline is if you wish to keep things sleek and lithe. There are side-by-side comparisons in the pictures of both.

Parts...16 different hand poses, including an unfused hand in case you wish to make a custom gesture.2 different sizes of sliding power lances with three different spiked heads each and three different styles of protective weapon shields.4 power shields (one round, one ornate).4 round shields (one standard, the other a lambda/Spartan pattern).Shield Adapters that let you bond factory or Suturus pattern hands to the back of your guantlets.Wrist Extenders.5 different angles of shoulders, fused to prevent weapon flop.Five different styles up upper arms with ball and socket joints.2 different upper arm protective plates.

This thing has it all!

Optimized for resin printers and factory kits magnetized at the elbow.

Edit: Added upper arms that enable you to use your Cervantes weapons on the new injection-molded Cerasti kits from GeeDubz.

Twist-lock on one side, 12mm x 3mm magnet on the other. Remember your polarities, and you're good to go!

Enjoy!

Best,JBR