Spongebob Squarepants, as 'Dirty Dan' the Texas outlaw.

Is 145mm tall. 743k tris in the model. All in STL files. A high resolution 3D-printable ONLY model. In 11 seperate pieces that must be glued together. It wouldn't be possible to make a spongebob any other way.

The thumbnail image shows the model finished and put together.

The second image shows the pieces in the correct orientation, in the slicing software.

sponge_hat - Important to print on its side with the U shape touching the ground, at .15mm layer height, 15% infill.

sponge_sleeve, sponge_arms, sponge_legs - Print on sides. Print at .1mm, 100% infill, all on their sides.

sponge_hands - Print with the thumbs up, and fingers sideways. Print at .1mm, 100% infill, all on their sides.

sponge_base, sponge_body, sponge_pants - Print right side up with supports, .15mm height, 15% infill.

If you follow those directions it will be very strong, I used PLA plastic.