Model is well done! Scales are amazing, properly realistic with a artistic touch. Lots of small details throughout the model, prints beautifully in resin. Face is slightly off, but that's common in anime style figures, it's really hard to nail, definitely not a down side. The pieces are cut very intelligently and fit together really well, plenty of room for print error. Overall I'm extremely satisfied and have no real complaints.
I am in the process of printing this amazing figure, I've already printed whole stand and I am couple pieces into printing Alice. For now I can mention 2 little things that may need to be adressed and/or fixed. The hole for the higher pillar is slightly smaller compared to the other one which results in base of that pillar sticking a bit too far from the floor level-I had to slightly cut the key for the pillar to make it fir properly and now it is okay. Other thing that I should mention is the fact that in my case the skirt has 2-3 holes when it is in cura slicer-it's a bit too thin in those areas to be properly processed. Its not a big deal since I can thicken those areas a bit using blender but still, thats another thing to take into consideration. Aside from that, it's an amazing figure and I can't wait to have it finished, especially because I made it slightly bigger than original so the stand halves barely fitted on the print bed haha. It should be awesome. When it's finished I will probably post the final result and also problems, if any more, occured along the printing process. Btw, I am using fdm printer Ender 3 S1 and UltiMaker Cura 5.2.2 slicer if anyone reading this comment was wondering.
