HOCKEY PLAYER POSE 8 MODEL NO TEXTURE 3D print model

Hockey Player model for 3d printing

I printed it in 2 parts, the entire model, so I can print the visor in a different material.

Visit my cgstore if you want to order other hockey player or a pack of poses instead!

Printed in 2 parts. You'll most likely need to Increase the horizontal expansion setting if you're having issues in your slicer software... Be careful when printing this model, make sure to have your print setting configured to be slower while printing the stick. printing something that small and tall will lead to bad layers since the layers wont have enough time to cooldown.

In ideamaker, there's a setting that makes the printer wait an amount of time if the time spent on the layer is below what you want it to be. I had it setup to 60sec, otherwise, there's a setting that reduce speed of details smaller than what you have configured.

I also added the stick printable separately so you can glue it in after.