Hellboy Hand - Height 150 mm 3D print model

This file is part of my Patreon welcome pack. To get this file at 100% off, support my Patreon. https://www.patreon.com/CloviSilva.

The 3D model is prepared and ready for 3D printing. Printing test performed on Creality LD-006 printer. Contents : Winrar file to unzip. In addition to the STL file, the chitubox file with supports is also included, the same one I used to do the test print. You can use it as a reference to place your brackets if you prefer.

Total de Pieces: 3 Approximate Height: 150mm

Tip for a good impression:

Make sure your printer is calibratedUse the correct timing for your resin/printerAfter printing, wash the piece and remove the supports by hand or with the aid of pliers, remove carefullyCure your partsFinish your piece with sandpaperPaint your piece and make your collection. Thank you very much.Hope you like it! ;D

Thank you for downloading and supporting! Please remember to rate my work ! thanks!