Bloodthirsty - Demons 3D print model

The pre-supports on the tails constantly fail. I have adjusted several prints, and lift speeds, etc. 9 of the 11 (including the character associated with these) have the tails fail pretty consistently. I highly recommend adding your own supports - but would have been extremely nice is to include the base filed to edit your own support (like in Lychee scene files).

Hello. We took a fresh look at the supports in the area of the tails. The supports are quite thick and increasing them will make it more difficult to remove. If it's still relevant for you, we can send you chitubox files.

We sent you a private message with a link to files in Chitubox format. We hope this helps you. Several years ago, when we were preparing the first files for sale, we tested our files a lot. Initially, we tried to make supports thinner, and make them as few as possible. We wanted customers to spend less resin, and the supports were easier to remove, leaving less damage to the model. We changed supports many times and achieved a minimalistic version when the model was successfully printed and at the same time there were as few supports as possible. Then we wanted to make another copy, but the previous bottle of resin ran out. We took a new one and started printing. Virtually all support fell away. We printed on the same printer, with the same settings, in the same room, the resin was the same, just a different bottle. But the result was strikingly different. Since then, we are deliberately making the supports a little thicker than necessary. Also with the quantity, there are probably more of them than is usually required. This is due to the fact that we are making pre-supported files for widespread use. They will be used on different printers, using different resins and under different conditions. It is very important for us that there are no falls. But resin consumption and ease of removal are also important. We try to find a balance all the time. Therefore, we are sometimes complained that the supports are too thick. But we have to make them so. And therefore, your situation, when the thickness of the supports is not enough, is very rare. In 3D printing, there are a lot of factors that affect the result. We hope that you will use the files that we additionally sent you for more convenient support adjustments. Sorry for the inconvenience, but not everything depends on us.