Two-pieces illuminated Street lamp, real lighting in your scale models!

With a simple diode led, a wire and a battery the lamp turns into a working light for scale models: The bulb screws around pole threads, and a diode led fits inside the head.

The walls of the bulb are very thin (0,8mm) thus making light pass through printing materials (tested on PLA and ABS). The pole is hollow allowing the wire to be connected down to the base and there is a large hole to allow for battery housing (standard coin-sized 20xx models) if you want the unit to be independently lit

It can also be serial printed and have all units connected in parallel to a psu and lit via a main switch, creating a nice dusk effect (for example you can use standard led switches or dimmers).

Threads are a custom M10 size, designed with high tolerance materials in mind (0,6mm) such as ABS or PLA.

Original measurements for the base-and-pole 12cm x 2.7cm x 2.7cm Scale 1:20Hollows Pole 4,2mmHead 7,2mm

Designed and optimized for supportless printing, since no angle goes above 20 degrees.