Plant pot pendant and badge collection 3D print model

Unisex,

Design Concept:Mutual benefit.These wearable plant pots keeps us all day time fresh and healthy. Growing a sapling or a mini plant until it gets strong enough to grow itself is difficult, by this way we can carry our little best friend with us anywhere until it reaches a certain height. So, it benefits person and plant mutually. The drain hole is not necessary as it requires less water, if drain required add a cylinder in the middle of required diameter and make it as a cut model in per-model settings.

Total available 9 models, this collection is great to grow saplings and mini plants. Currently I'm wearing Pudina(mint plant) the fragrance is so sweet.

Commercial License:You can print and sell these models.

Video link: https://youtube.com/shorts/Huxjxa-gW3o?si=2c18NklkaJAVdIVY

Wearable modes:

1. Pendant: The bail is easy to host chains up to 5mm diameter beyond that you can use a jump ring.
2. Badge: The rare side has two rings, where a safety pin or a pin can be used to pin it to your dress.

3D printing settings:

Printer: FDM / RESIN,

Filaments: PLA, PETG, ABS, E.T.C,

Retraction: 4mm speed 60,

Nozzle Temp: minimum 190 to 210 C bed 90 C for PLA (no glue stick/adhesive needed)

Infill: Minimum 5%,

Print in place,

Support: No supports needed, if necessary turn on make overhang printable.

Ignore water tight error,

Layer height: lower the layer height higher the details, the current print pictures in the model printed at a layer height of 0.08mm with 0.4mm nozzle each model took around 1 and half hour to print.

Build plate adhesion: brim at least 5mm,

Thank you,

Have a cute day.