Mother of all bins multipplication bin 3D print model

This is the mother of all bins !

Works in multiple aplications .Has 3 sizes , short , medium or tall !Can be attached to a desk , table or shelf .Can be hanged from a cabinet door , drawer .Can be screwed on to anything . -With the removable rim and lid assembly , it allows for a plastic bag to be installed and kept in place ! -Very easy to print , you can use the biggest res you have available and go as fast as you can extrude !

As said above , you can print in any resolution , and as fast as you can !

All the printing times below were sliced at .32mm , 3 walls and at 125mm/s !

-Short Bin 7 hours and 36 minutes .-Medium Bin 9 hours and 51 minutes .-Tall Bin 11 hours and 39 minutes .-Lid 3 hours and 29 minutes .-Rim 1 hour and 15 minutes .

Still .32mm but with 50% infill and 80mm/s .

-Clamp body 1 hour and 21 minutes ( Has a tiny support built in , right on the attachment point , just pry it off or cut it , no further work required).-25mm Hanger 21 minutes .-18mm Hanger 20 minutes .-15mm Hanger 20 minutes .

At .2mm 50% infill .

-2 Bolts 1 hour and 20 minutes .-2 Lid Arm 20 minutes .-2 Clamp Slotted Nut 10 minutes .