J
juansottile juansottile
PRINT IN PLA OR ABS FILAMENT
UPDATE 17 DE SEPTEMBER 2018:
-ADDED TO THE COVER FOR THE MANUFACTURE OF THE VASO ALREADY WITH THE HOLE AND WATER OUTLET.
-HAS BEEN ADDED TO VERSION 2 OF THE LATTS FOR USE WITH THE COVER.
MOLD_Side_1 and MOLD_Side_2 (~10 hours @ 60 mm/s)
Filament choice not important 0.2mm or greater layer height 20% infill (I chose fast honeycomb pattern) Support not required
LOCKS (~2 hours @ 60 mm/s)
Filament choice not really important 0.2mm layer height 30% infill Support not required
MOLD_cover_x1 (~4 hours @ 60 mm/s) Filament choice not important 0.25mm or greater layer height 30% infill (I chose fast honeycomb pattern) Support not required