Coffee Filter Holder 3D print model

For a coffee at the old school. the wall-mounted coffee filter holder.Very easy to print because composed of several parts.An identical face and bottom and clips to connect the two.Half an hour for each side and a few minutes by clips are only necessary for this essential accessory for a coffee maker.A small hole allows fixing to the wall.The basic capacity is forty # 4 filters.

Parameter on repetier for RepRap prusa i3Extruder: 200 ° C and bed: 55 ° C Layer height: 0.3 mm Vertical shells, perimeter: 3Horizontal shells, solid layer top: 3 and bottom: 3 Fill density: 20% No support material Speed perimeters: 45 mm / s