1/11
Happy Halloween, everyone.
The Ultimate Halloween Pack will definitely help you get into the spooky spirit.
This pack includes:
Disclaimer:For the Lamp and Jack O'Lanterns, the idea is to add a light source to get the full effect, however, please DO NOT use real candles due to fire hazards. As a safer alternative, use these electric candles instead, as they will provide the same aesthetic results.
Suggestion 1:Not mandatory, but on the Happy Halloween sign you could print the ghost with glow in the dark material for that extra touch.
Suggestion 2:For the witch cauldron, you could paint the liquid pouring out with fluorescent or glow in the dark paint to spice it up.
Suggestion 3:For the Bat Silhouette and Happy Halloween sign, you could use double-sided tape to stick it to the walls or a magnet to have it, for example, in a refrigerator.
Note:In the Happy Halloween Sign, I will provide a one-piece item (all assembled) as well as all the individual pieces by themselves. This way, you will just have to print what better matches your needs.
The Tombstone 1 dimensions are the following (mm):
Height- 211
Width- 113
Depth- 64
The Tombstone 2 dimensions are the following (mm):
Height- 211
Width- 113
Depth- 65
The Tombstone 3 dimensions are the following (mm):
Height- 210
Width- 100
Depth- 60
The Bat (laying down on the plate) dimensions are the following (mm):
Height- 4
Width- 185
Depth- 88
The Lamp (Lamp with Lid) dimensions are the following (mm):
Height- 250
Width- 136
Depth- 136
The Happy Halloween Sign (fully assembled and laying down on the plate) dimensions are the following (mm):
Height- 10
Width- 229
Depth- 157
The Spider dimensions are the following (mm):
Height- 30
Width- 190
Depth- 188
The Pumpkin 1 dimensions are the following (mm):
Height- 68
Width- 89
Depth- 89
The Pumpkin 2 dimensions are the following (mm):
Height- 79
Width- 89
Depth- 89
The Pumpkin 3 dimensions are the following (mm):
Height- 74
Width- 89
Depth- 89
The Witch Cauldron dimensions are the following (mm):
Height- 113
Width- 160
Depth- 157
Sculpting software used: Blender
Render method used for the previews: Cycles
Filament: PLA
Slicer used to 3D print: Ultimaker Cura
Settings I've used to 3D print:
Standard quality - 0.2mm
Infill - 20%
Supports - Most of the items as support free, but in some cases, like in the Lamp lid and Jack O' Lantern top you might need them. So, just check in your slicer the best way to print them.
Speed - 50% first 20 layers and 100% for the rest
Plate Adhesion - Skirt
Cooling - Enabled
Travel - Retraction Enabled
