Commercial License:You can print and sell these models.

Total available 2 models.

1. A wall art of approximately 220mm2
2. A puzzle cum wall art; after printing it you can play with it like a puzzle or can glue it to the wall after assembling.all the pieces are splitted to fit almost all printer build volumes.

3D printing settings:

Printer: FDM / RESIN,

Filaments: PLA, PETG, ABS, E.T.C,

Retraction: 5mm speed 60,

Nozzle Temp: minimum 190 to 210 C bed 90 C for PLA (no glue stick/adhesive needed)

Infill: Minimum 8%,

Print in place,

Support: No supports needed,

Layer height: 0.24, (use high diameter nozzle for fast printing)

Build plate adhesion: brim at least 2mm,

Thank you,Have a pop day.

Regards,Sigma Designers.