Intel wafer storage box gaming decor 3D print model

3D MODEL DESCRIPTIONWith you are like me and always wanted one of the Intel Silicon Wafer , then look no further than this Design !

-Not only being a very cool decor , it double as a smart storage !

• It is modelled to look as close to the real deal as possible but still being printable !
• The Wafer Box has a few choices of storage design :

1-Compartmented for screws labeled with m3/m4/m5 and with 4 screwdriver holder holes to use when the box is open !2- Slotted for SD and Micro SD cards .3-Single simple compartmented .4-Double compartmented .

5-Triple compartmented .6-Quad Compartmented .

And it is a very simple print , no fancy mechanisms , latching system , no further hardware needed , no glueing , no assembly , its just print and use it !

3D PRINTING SETTINGSThe box is 100x30mm thick , the base is 110x110x25mm !

Printing time will vary beetween models !Below is the printing time for each specific part using cura at .2mm 20%infill (NO BED ADDHESION!!)

Wafer Lid : 4 hours and 10 minutes / 28g

Simple compartmented : 4 hours and 36 minutes / 35g

Double compartmented : 5 hours and 29 minutes / 42g

Triple compartmented : 5 hours and 56 minutes / 44g

Quad compartmented : 6 hours and 13 minutes / 46g

Memory Cards : 8 hours and 31 minutes / 68g

Screws Compartmented : 6 hours and 41 minutes / 51g

Base : 4 hours and 16 minutes / 40 g