Cat Key Holder - STL for 3D printing -Animal Keys Hanger 3D print model

Beautiful cat design house key holder with four hooks. There are two cats sitting. The holder can be attached to the wall with Double-Sided Film Tape or with two screws. The item is about 15 cm wide and 14 cm tall at the tallest point.

It is recommended to print these models with a good FDM Printer by using some supports enabled, however you can also use a DLP or SLA printer with resin as well.

You should use a good 3D printing software such as “Ultimaker Cura” with the option; “remove all holes” activated or another qualified 3D printing program for the best results.

For small scale printouts, it is also advised to use “Superior Quality” setting if possible.

Please keep in mind that these are 3D Print models for personal, non-commercial use only by hobbyists and fans.

Do not under any circumstances, share or modify these files for free or commercially! Under no circumstances, we will be held responsible for any loss or damage resulting from the misuse of this service and you will be entirely responsible for it.

*** It is very valuable to us that you like, rate and comment on the products of your liking. *** If you have a question or a request, please do not hesitate to contact me. ***