Hi guys, I recently learned to use Fusion 360 and this is my first completed project. I think the castle looks pretty cool and Vector's charger fits perfectly. This structure will look nice on a big desk or table.

I printed mine with the following parameters:Resolution: 0.2Infill: 20%Walls: 1.2 (to avoid zizag infills, which takes more time)

Supports are needed especially for the arch doorway. I designed the towers with a 45 degree inverted roof inside them to avoid support in these 4 areas. But my Cura slicer insisted in putting support in these areas(?). Obviously you could also print with white plastic and paint the colors you want. As you print or in preview mode in your slicer, you will notice that the walls go inside the towers. I did this to have more rigidity in the whole structure.

I hope you enjoy!