Wall mount that clamps to the tire.
This one is for 2.6" tires -> width = 66 mm
Print in PETG with 230/85°C Suggested setting on PrusaSlicer: 0,35mm Layer height 3 perimeters 10% infill Infill pattern : Archimedean Chords Top fill pattern: Archimedean Chords Bottom fill pattern: Archimedean Chords No support needed if model is placed as in picture when sliced.
The bracket is made as a fishtail and the holder slides on to it. You can print multiple brackets and move the holder between for different positions/places or to change between bikes. Same bracket fits between different sizes of holders.