Star Trek III Phaser Type I and II 3D print model

In looking at the exploded view here, you don't have models in here to fill in the caps/holes in the Phaser 1? Not everyone wants to install electronics...

I don't have any, but you could just put a piece of colored or clear foam inside to fill in the holes/caps and then glue it all together

Hmm... I was just hoping the model actually was complete.

This model needs to be resized. I downloaded the files as is and loaded them into my slicer. I was a little puzzled when the estimate was only 4.5 hours. Nevertheless, I began the print job and a few hours later when I checked on it, it appears that the model was printing at maybe 1/2 scale.

Hi mechamaniacal, I checked the files and the model is in the correct scale for printing as requested by the first person who ordered it in the measurements of 140x90x31mm, if it is outside of these original creation measurements then it needs to be rescaled, now if it is in these measurements and you found the model small you can scale the model by 30% directly on your slicer so that it has a better fit for your hand.