The design looks great but you will run in too issues,
-when printing fuselage 3, there is a lip on fuselage 3 that prevents it from be flush again fuselage 5. you need to cut it off.
-The rear wings on the engines do not fit
And even if you print with a 0.2 nozzle you will not be able to print the mini guns. Which is very disappoint considering the cost of this model.
Another negative point you think for the cost there be a stand for this model.
So have to give a thumbs up for the design but thumbs down for the printability
So far I have not had too many troubles. I did have one minor repair on hull piece 1, as well as needing additional support material. The print quality so far is looking really good, and the slicing did not require too many oddball settings once I had the supports set that I needed.
I will warn people to look REALLY close at their overhangs. There are unexpected protrusions that will require supports, and you will cry if it gets missed.
Details from the STL show up nice. I have only started on the first piece of the entire print but I feel that the quality is great, and was worth the price of the STL files.