Mythosaur Skull Mandalorian Helmet printing armor helmets 3D print model

This is my custom Mythosaur Skull Mandalorian helmet based off of my Jango Fett/Death Watch helmet Model. Same as the Boba Fett but no dent. I wanted a helmet that was different and stood out but wasn't goddy or covered in a ton of greeblies. This helmet is probably one of my favorites so far for my personal use.

This helmet has removable ears and borden connector. My other Fett helmets print super nice and clean.

This helmet should print just fine with zero supports in the center and fit on a 300x300 bed.

I tried to make this as close as possible size wise to the original used helmet and will be comparing it side by side to an early generation casting to make small adjustments.

Please, Do not share/resale the 3d model

Please feel free to message with any other questions or reguests! If you like my designs/models check out our instagram Grizzlymountaindesigns or for even better deals then on here join the patreon, same name!

I do custom models so let me know if there's anything you think would be a good hit!