Morningstar Weapon 3D print model

Dsigned for easy 3D printing without the need for supports. This model comes in just two pieces: the handle with chain and the spiky ball. Assembly is straightforward; simply use a bit of super glue to attach both halves of the spiky ball, and it's ready to go! For an ultra-realistic finish, I painted mine using an oxide paint, which includes iron filings and an oxidation activator—this kit is readily available online. To achieve a rough, rust-peeled texture, you can also apply kitchen paper with the same oxide paint. This added touch enhances the rugged, ancient look of the Morningstar.

Printing Settings:

• Printer Model: Prusa i3 MK3S
• Layer Resolution: 0.2mm
• Nozzle Size: 0.4mm
• Slicing Software: PrusaSlicer
• Filament Material: PLA
• Bed Temperature: 60°C
• Nozzle Temperature: 210°C
• Supports: No
• Infill Percentage: 15%
• Brim: Recommended

Printing Information:

• Estimated Printing Time: 9 hours 20 minutes
• Print Volume: 200mm x 115mm x 200mm

Additional Information:Ensure your printer is well-calibrated and the bed is leveled for optimal results. Maintain bed adhesion by keeping the bed clean and free of grease. Use isopropyl alcohol for cleaning and apply adhesive if necessary.