Druid Horns Headband 3D print model

Deer antlers with headband. I made it for a friend who used it at a ComiCon convention. It can be for a cosplay of druid, elf or whatever you want. The horns are printed separately and the headband too. Then you can use some glue to hold them in the desired position.

Printing Settings

• Filament Material: PLA
• Layer Resolution: 0.2 mm
• Infill Percentage: 15%
• Supports: Yes
• Brim: Yes
• Bed Temperature: 60°C
• Nozzle Temperature: 210°C

Printing Information

• Nozzle Size: 0.4mm
• Estimated Printing Time: Approximately 13 hours 35 minutes
• Printer Used: Prusa i3 MK3S
• Slicing Software Used: PrusaSlicer
• Supports: Only Minimal on Headband Connector

Additional InformationEnsure your printer is well-calibrated and the bed is leveled for optimal results. Maintain bed adhesion by keeping the bed clean and free of grease. Use isopropyl alcohol for cleaning and apply adhesive if necessary.