Ender 3 V3 KE bookmark 3D print model

Contest winner: This model won 2nd place in creality cloud's Bookmarks design contest https://www.crealitycloud.com/contest/bookmarks-design

Commercial license: You can print and sell these models.

A miniature best friend Ender 3 V3 KE bookmark who helps in your work to mark the progress in your book with an arrow pointing your resume point. The extruder model is a snap fit which can slide to and fro. The printer length is just 36mm including the spool it is just 40mm / 4cms which will be very handy to use.

The spool model is snap fit, insert the filament T shape end in the spool top middle hole and press the spool top against the bottom then you can roll the filament model and pass it through the extruder before attaching the extruder to the printer.

Available 2 sizes: large and smallMaterials:PLA, Resin, E.T.C

3D printing settings:

Printer: FDM / RESIN,

Retraction: 5mm speed 60,Nozzle Temp: minimum 190 to 210 C for PLA,Bed Temperature: 90 C (no glue stick/adhesive needed)Infill: Minimum 8%,Print in place,Print speed: 25Support: No supports needed, Layer height: 0.1 to 0.2Build plate adhesion: brim at least 1mm,Line width least available,You can also scale the model to your required size.

Total print time:Small : less than 45minutes,Large : 1hour 15 minutes,

Thank you,Have a wonderful day.Regards,Sigma Designers.