Star TRek Discovery Emperor Sword as seen in the Mirror Universe episodes, season 1. 8mm and 5mm metal rods can be used to support the inside, or use the short printable versions as 'biscuits'. The Scabbard should be assembled in 2 halves - FRONT, and BACK. They can then be lined with up to 2mm material, foam or felt etc for protection. there is allowance for 2mm lining. The front and back of scabbard can them be attached using the small pilot holes and pins, with glue. There are 4 versions of this sword, and 2 versions of the scabbard depending on the size of printer. The image files show the various versions you can print. There is a finished version of the handle, with the gold wraps around, and one withou, if you wish to wrap yourself after painting. There are also 2 versions of the Terran emblem - one with 3D landmass on the Earth, one without. If you look at my other models, you will find there is another version of the sword hilt that is not part of this purchase. That other purchasable version is the original sword hilt that was then redesigned to be the final one you see in the show. THE SWORD IS APPROX 918mm LONG.