Let me introduce to you the PowPaw - Bear!

This pole basket leaves bear paws imprints in the fresh snow or soft mud. It just adds a little bit of fun to your outdoor activites and is a great way to motivate your kids to get out and play in the great outdoors.The file fits most ski poles with screw-in baskets.

If your baskets are press-fitted on your poles, these will require more tinkering, but here is a tip:To remove the pressed basket, use a flat wrench in combination with a hammer to pop the previous basket. You can apply some heat to soften the plastic too.-To mount the new basket, apply some neorprene glue on the inside of the threads before pushing the basket into place. It should be sufficient.

Printing parameters recommended : -TPU-0.1 to 0.4 mm layer thickness depending on your nozzle.-5 walls-5 bottom and top layers-20 percent infill with a gyroid infill.

No supports needed.