Airbus A320 tiller grip 3D print model

A320 or A3XX Tiller Hand Grip (captain and first officer side)

Tiller included the 10mm hole for your base on wiring.

You could modify in certain degree to fit your flight sim setup.

3D PRINTING SETTINGS

I would recommend RESIN for better and fine appearance.But you will need to paint it in black

FOR PLA or PETG printing (Black)

Layer Height:

Recommendation: 0.1 mm to 0.2 mmExplanation: A smaller layer height will give you a finer resolution, capturing more details of your model.Print Speed:

Recommendation: 40 to 60 mm/sExplanation: Slower print speeds improve print quality by allowing the filament to cool and adhere properly.Print Temperature:

Recommendation: 200°C to 220°CExplanation: PLA generally prints well within this range, but you might need to adjust slightly based on your specific filament brand.Bed Temperature:

Recommendation: 60°CExplanation: Helps with bed adhesion, reducing warping and ensuring a smooth first layer.Infill Density:

Recommendation: 20% to 30%Explanation: Provides a good balance between strength and material usage. For non-structural parts, you can go lower.Shell Thickness:

Recommendation: 1.2 mm to 1.6 mm (3 to 4 perimeters)Explanation: Increases the strength and smoothness of the outer walls.Cooling:

Recommendation: 100% cooling fan speed after the first few layersExplanation: Helps PLA solidify quickly, maintaining sharp details.Adhesion:

Recommendation: Use a brim or raft if you experience warpingExplanation: Ensures that the model adheres to the bed during printing.Retraction Settings:

Recommendation: 1 to 2 mm retraction distance at 25 to 40 mm/s retraction speedExplanation: Minimizes stringing and oozing between parts.