Air blower nozzle 3D print model

An air nozzle to use with compressed air, used for the concentrated, targeted application of air. Lower air consuption than a simple open pipe with very low noise.The thread is 1/4" BSP pipe thread. If you need another thread, please contact me .Tested with 6 kg/cm2 air pressure, giving 100 grams of force at 30 cm distance, which is the same value that a commercial aluminum nozzle delivers on same conditions.

I used 0.08 mm layer height for the thread. Where the exit holes are located (from the base of the model up to 18 mm) is recommended to also use a small layer height (again 0.08 mm in my case) for good definition of the aire passage geometry. Rest of the body can be 0.25 mm for example. 100% infill, but you can try with less. I used 6 perimeters.