Schumacher XTR 3E - Nitro 10 - 21XTR - Front and Rear Wishbones 3D print model

Thread the shock absorber mounting holes with an M3 tap if you print in resin and youre all good!Just be careful where you put your supports so it doesnt sag in all the wrong places.I rasied it above the platform a bit and supported the whole thing. Once supports are removed you can sand smooth and clean with a liquid tyre shine and it'll look fantastic.I used ABS like resin and could barely tell the difference between this and the original part.Original part numbers are U8305 & U1135.