The is an aftermarket cup holder that I designed, and 3D printed out of PETG. It is designed to go where your ashtray was and use your ashtray bracket. The inner diameter of the cup holder is 3.6and I included the files of inserts that bring the diameter down to 3, 2.75and 2.5. I used two 1” #12 sheet metal screws.

** To install this, remove your ash tray bracket. Take the white plastic sliders off of each side of the bracket. Put it on the cup holder as shown above. Put the bracket back in place and screw the screws in using a 5/16 socket.