Made for the M1 Abrams T158.

The models are made standard in scale 1/48 - (14 mm / 1/8 Inch wide), but can be scaled up and down as desired.
Not suitable for other than SLA printers and preferrably with a high resolution

Two different models.A model has been made as a click system and a model that can be assembled with a pin if the belt must be functional.

The functional model:

In scale 1/48, the hole to assemble the belt is a little more than 0.5 mm (0.019 in) in diameter. Copper from a wire may be used to connect the joints.

The model with click system:

This model can be advantageously used for stand models. Very easy to assemble and works well. When the belt is assembled and hangs naturally and as desired, it can be glued into position. Usable for scratch building. Might fit some kits.

Added the joints in rows of 8 for printing sets. You will need 152 joints for a T158 or 19 sets of rows.