Upgrade Kit for JInbao OS KO of Warabtron Bruticus 3D print model

I have been made aware of an issue with the notes for the hand assembly. Each hand on the original set requires 4 x 4-40 screws with a thread length of around 8mm. The upgraded set requires 5 x 4-40 screws with a thread length of 8mm. This can be substituted for #4 screws as well, as long as the thread length is the same. Also the notes state 1 x 4-20 1long screw is required which should state 1 s 4-40 with 1 in thread length is required to hold the ball joint to the wrist. For the 2.0 version of the set a 1 x 6-32 1" thread length screw is requred to hold the ball joint to the wrist.

Update March 19 2024: I have added a 2.0 version of the upgrade kit to the file set as a complete zip file. All of the files to make the upgrade kit are in the 2.0 zip file along with a list of changes and improvements which are as follows:

Bruticus Upgrade kit 2.0 - Changes and additions

1. Removed the front facing seam on the lower thighs
2. Added Toon styled thighs
3. Increased the size of the Hip skirts and added an optional set of split hip skirts for ease of printing
4. Added an optional component that tabs into the back side of the toe to prevent forward tilt of the Ball joint in the heel
5. Increased the size of the Wing assembly and enhanced the details
6. Added more details to the hand with separate glue in detail pieces for ease of paint or printing in different colors
7. Reduced the tolerances between many ratchets and their housing to add some friction resistance to the spring ratchet setup
8. Add two option components that tab into the back of Swindle and Brawl to ensure they do not separate at the toe
9. Increased the front to back thickness of the Waist to eliminate the slender look and enhanced the cod piece
10. Increased the thickness of the upper back Midsection and added some molded details
11. Added new Upper side Body adapters that reposition the arms further away from the body and increase the width of the upper chest
12. Increased the neck height on the head by 2mm so that his head sits slightly higher up between his two shoulders.

Also I have uploaded a separate model set that utilized the left over trailer and converts it into either a Big sword or a Massive Gatling Gun with ratching barrel.

https://www.cgtrader.com/3d-print-models/games-toys/toys/sword-and-bfg-gatling-gun-out-of-jb-bruticus-onslaught-trailer

I was inspired by the design done by LikeToys for Jinbao's OS Gravity Builder Aka Devastator. I wanted my Jinbao OS KO of Warbatron Aka Bruticus to match heightwise and the new asthetic as well. So I came up with this upgrade kit that give the Combiner a great deal more height and a more MP asthetic. Check out all the video and photos and make sure to read through all the notes. Also the better the compression on your springs the better the hold on the joints will be.