Trigun Stampede - Meryl - Roberto Derringer Replica Costume Prop 3D print model

NONFUNCTIONING REPLICA PROP - While it does have some moving parts, this is nothing more than a toy.

Thank you for your interest in my models! If you have any questions or comments about my models feel free to message me!

Model Info:

This model is for personal use only and is not to be distributed. Commercial use must buy a new copy of the model set for each physical item produced using any of my designs.

This model has been designed with a moving trigger and opens and closes using a few screws and springs, but you can also opt to glue everything together instead if you would rather not get the hardware. (The models of the screws seen in the renders are not included with the file set.) Below is all the hardware I used myself. The Larger 6-32 screws are for the wood grips, and the smaller 2/56 screws are used for everything else. One spring is for the trigger, and the other goes inside the Front Body to push the Slide back. The model is about 125mm long by 80mm tall by 30mm wide when assembled.

14x 2/56 x 1/4 Slotted Flat Head Screws/

2x 6-32 x 5/16 Slotted Flat Head Screws

2x 3mm OD x 10mm Long Compression Springs