Transformers Teletraan-1 Enhanced Version 3D print model

And now after all this time, it's apt to circle back to the very first model which we started off with to give it a much needed refresh!

Keeping a similar scale to the earlier Teletraan-1, here's how the new version sizes up against Prime and Prowl here.

Took the chance to give it a lot of detailing and placement of 5mm ports which are handy to attach accessories on!

A pair of front facing 5mm port can also be used together with rubber tubing to connect Teletraan-1 to your bots!

And with the recent release of the Golden Disc with various figures, a little slot for it has been designed also! Now Teletraan-1 can also backup and transfer its files ;)

And here's a side-by-side comparison with our earlier Teletraan-1, marking quite the journey we've taken on so far, won't you say?

=== Assembly ===

The included diagram shows all the parts of this build and how they go together.

The parts connect together using 5mm pegs which can be 3d printed out using the provided files, or cut down from 5mm rods.

Though using the 3d printable pegs would allow the entire set to be scaled up if you prefer to do so!

===

Hope everyone enjoys this refresh to our very first piece, after all this time!

As always. have fun with this one and here's looking forward to many more models to be shared with everyone as we plod onwards! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog