Transformers Phreaker from Cybertron 3D print model

A fellow buddy of Signal Lancer's whom we never got to see transform - here's Phreaker with our imagining of how he could have been!

The phone booth he sits in for his alt mode turns into his little signals base as he helps to keep track on the communications of the Decepticons.

Sitting in his very non-descript alt mode, Phreaker blends in perfectly within the urban landscape (or less so when he chooses to turn up in some forested wilderness)

In his bot mode, Phreaker is very much similar to other micromaster class bots.

As for his booth, it lays flat down for its little base mode with a little radar dish which is normally hidden in the top lid of the booth, which unfolds to attached onto stand, which can be angled to better intercept enemy comm signals!

And if you have a short segment of 5mm rubber tubing lying around, the radar stand can be connected up to the base itself!

=== Assembly ===

The included diagram shows the assembly instructions for both Phreaker and his booth-base.

Given his small size, this can be a little challenging to put together.

Many jointed parts are to be assembled with 1.75mm filament cut down to length as pins.

For Phreaker's arm_pegs, its likely that you would choose to superglue them into place to make them more solid.

===

Hope y'all enjoy our little take on this obscure character from back in the Cybertron days. A fun little pal to join Signal Lancer if you have him already.

Happy 3d printing as always!

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog