Titanium Saber for Transformers Legacy Metalhawk 3D print model

To help equip Metalhawk with a more lethal looking weapon, here's a sharpened version of the Titanium Saber he comes with!

Largely designed to get rid of the filled area which the original accessory had, the saber's shape was also designed to make it more akin to how it appeared in the animation, including adding back the detailed curves motif on the blade which its original iteration had.

Took the chance also to add 3mm effect pegs on both ends of the hilt! Helps Metalhawk look like he is deflecting stray blaster shots !

And if you have Skullgrin armed with the earlier Vibro-sword (patreon.com/posts/76100453), you can pitch these two in heated battle!

When not in use, the saber can be stored by pegging onto Metalhawk's wings.

And to make it easier for printing in case the blade details are a little tricky to pull off, a version with a clean blade is also included.

Coming over to his jet mode, this saber can be pegged atop his fuselage, similar to how the original did it or it can also be attached to the 5mm port using the peg on the other side.

Or, since it's all 3d printed, do a pair and attach them under the wings like really stabby little missiles!

=== 3D Printing ===

Being a single piece model, for FDM printing, it is suggested that the print be orientated something like shown in the included image.

This should print beautifully on resin 3d printers too!

===

And there we have it, an enhanced blade that hopefully brings a bit of animation accuracy and an homage to the original piece! Happy 3d printing, y'all! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog