Sword and Remote Bombs for Transformers Legacy Skyquake 3D print model

Continuing with more fun addons for Skyquake, here are his sword, remote bombs and detonator!

These additional weaponry will serve Skyquake well in the heat of battle!

First up on the sword, this stands in for the smaller piece which Skyquake came with and cuts a much more imposing look for him.Took the chance to add a little 3mm peg on the top of the sword which makes it blast effect compatible.

When not in use, the sword can be stored by sliding it into the back slot in Skyquake's 'backpack' ready to be yanked out when the time calls for it!

The other half of this set is comes in the form of these remote bombs and the flip-phone like remote detonator!

Like the sword, a variant of these bombs come with a 3mm peg on top for effect parts to be added!

Now, these smaller pieces were sized to be just thin enough to be held in Skyquake's (thankfully) open hands. The remote, taking on a flip phone format, has also been designed to be able to flip open and close like one.

These addons also work just as well with original Prime version of Skyquake!

=== Assembly ===

The diagram attached shows the various bits of this addon set.

The sword come in two versions - one with the top and bottom bits separated to make for easier FDM printing, and another as a single piece in case you are looking to resin 3d print it.

For the bombs, they come in 2 versions with either a 3mm or 5mm port on the back, and also 2 variants with or without the 3mm peg on top - making for a total of 4 variants. In cases where you would like to attach it to bots' 5mm ports, a short 5mm peg has been provided to allow for the.

The remote detonator comes in top and bottom parts which are to be connected using either a short segment of 1.75mm filament or a paper clip.

===

Hope y'all enjoy 3d printing these for your (either new or older!) Skyquake too to make him more complete! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog