Starscream Coronation Plaza Statue from Transformers the Movie 3D print model

Flanking the sides of the very grand plaza where Starscream (almost) had his coronation were stoic statues, probably of notable Transformer warriors from the past.

Hence, adding on to the earlier Coronation Stage ( https://www.patreon.com/posts/51908134 ) and tiles ( https://www.patreon.com/posts/51908134 ), here's a shot at doing up one of those towering statues, staring down from the pedestal!

To make its easier to print and also open up the possibility of customizing additional different guardians for the plaza, the statue and pedestal have been modelled separately.

To give a sense of scale, here's Starscream himself standing right next to the statue.

More of these would make for a merrier setup, and we'll leave that for y'all to give a shot!

=== ASSEMBLY ===The attached diagram shows how the parts of the statue and pedestal fit together. To make it neater, they have been grouped into two different sub-folders within the attached zip file.

For the Pedestal, the back portion comes in two versions - (a) one split into 3 parts and (b) a one as a single piece. It can be made taller but vertically (and non-uniformly) stretching it vertically too!

===

And there we have it, a somewhat oft-requested Coronation Plaza Statue! Happy 3d printing this and hope you have fun customizing perhaps other versions of the statues of your own too! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog