Space Bridge Part 2 from Transformers Netflix WFC Siege 3D print model

*** NOTE: Part 1 (https://www.cgtrader.com/3d-print-models/games-toys/toys/space-bridge-part-1-from-netflix-transformers-wfc-siege) is required to build up a full Space Bridge model ***

Here's the promised end piece to complete the Space Bridge from earlier (https://www.patreon.com/posts/space-bridge-1-40700126). More details on this build are in the original post too!

This second set provides rear sections which have smaller inner bits, making them somewhat different from the forward bits.

They make use of the same types of pillars also to make it uniform with the pillars from the 1st set.

And of course, after 3d printing was done, wiring up with EL wires is both the fun and dexterity-challenging bit to make it all come together as a single unit. For our piece, we used another 3M section of EL wire on a separate circuit so the front portion and rear portion can be turned on separately (video below shows that).

But if you are looking to wire everything on a singular circuit, getting 6.5-7M of EL wire would be a comfortable length to work with!

====

Also, had to take a couple of shots of various bots coming through the Space Bridge.

Here's a quick clip showing both parts of the Space Bridge in action together -

Have fun 3d printing this one to complete the Space Bridge! ;)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios