Smokestacks and Afterburner Effects Pack for Transformers 3D print model

Now with effect packs mainly not officially packaged in with our bots, thought it would be fun to do up this twinpack of smokestack and afterburner effects!

First up - the afterburner effect has a 5mm peg at the end which will fit into any standard effect port.

Here it is printed out in clear PLA and then topped off with a coat of clear orange paint and attached into Starscream's thrust Print out a pair of these parts and they work awesomely also for twin afterburner setups, like for Skywarp here!

And for the smokestack effect parts, they were initially designed to fit on WFC Optimus Prime so we can have this iconic view of Prime with his smoking stacks as seen from the front!

Along the way, we also wanted the same look to be possible for Legacy Armada Prime. So, some slight tweaks were needed to create a twin stack version to fit specifically for him!

Again, these were printed in clear PLA before given a dark grey paint wash!

=== Assembly ===

All the bits in this pack are single part prints as shown, but just to explain their naming:

SmokeEffect-4.3mm - This is meant to fit WFC Optimus Prime and others of the same mold type

SmokeEffect-3.1mm - This is sized to fit the more generic 3mm pegs on bots

SmokeEffect-ArmadaOP - This is the twin stacked version for Legacy Armada Optimus Prime.

Afterburner - This is a generic sized 5mm effect part

===

Hope these couple of new effect parts will be useful in adding some blooshy dynamism to your collections! Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog