Proton Pack and Accessories for Transformers 3D print model

Making a slight crossover to another beloved series, here's the Proton Pack and accessories! Designed and sized for Earthrise Optimus Prime, this set should nonetheless fit any other transformers figures which has a 5mm peg hole on its back.

Together with proton pack, this set also includes the particle wand and a ghost trap for more display/play options. Alternatively, Prime's blaster also very nicely has a side 5mm peg and can be used too!

To connect these separate pieces, a segment of 5mm rubber tubing can be used, as shown here. Of course, the front of the particle wand would also allow Siege effects to be fitted on it too!

Of course, if you had a ghost of starscream, this would be a more fun display setup! But too bad, didn't have one handy so this PotP Starscream will have to do. Just remember to toss the ghost trap first!

As an additional mode, attaching some siege effects in the bottom thrusters of the backpack also allows it to be used as a jetpack of sorts!

Ah yes, so there you have it! Have fun 3d printing one (or four for a full team?) to outfit your bots with ;)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios