This is a sectional modular nerf blowgun. It shoots Nerf darts quite well. There are 5 required pieces to print, that all interface with each other. If you want the blowgun to be longer, you can print more bullet chamber pieces. The longer the chamber, the faster, the bullet goes on exiting the blowgun.
Rangers
The ranges of the blow gun with 1, 2 and 3 tube sections (these rangers use a Nerf bullet, not custom projectiles).
- 2 tube sections = max range of 40 feet (12.19 m)
- 3 tube sections = max range of 45 feet (13.72 m)
- 4 tube sections = max range of 50 feet (15.24 m)
Assembly
- Print all the required pieces
- Screw the bullet chambers together with connectors.
- Screw the mouthpiece onto one end
- Screw the scope onto the other end
Required Pieces
- Scope (1x)
- Bullet Changer (the more Bullet Chambers, the faster, the bullet goes)
- Connector (half the amount of Bullet Chandler)
- Mouthpiece (1x)
Printing Instructions
- Material: PLA or PETG (for extra strength)
- Supports: Yes
- Mouthpiece
- Bullet Changer
- Connector
- Brim: You may need a brim on the mouthpiece
- Orientation:
- Lay the scope on its back
- Lay the bullet chamber on its side
- Put the connector vertically on the build plate
- Place the mouthpiece vertically on the build plate
If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.
